Listar QUI_Articles por título
-
Influence of solids concentration on the microstructure of suspension plasma sprayed Y-TZP/Al2O3/SiC composite coatings
Elsevier (2019)The present research focuses on the effect of feedstock suspension solid concentration on the microstructure of suspension plasma sprayed Y-TZP/Al2O3/SiC composite coatings. For this purpose, concentrated aqueous suspensions ... -
Influence of starch content on the properties of low-cost microfiltration ceramic membranes
Elsevier (2015-12)The use of starch as pore former is frequent in the fabrication of porous ceramic membranes, since starches are cheap, innocuous and environmentally friendly. A study has been conducted to evaluate the influence of potato ... -
Influence of the feedstock characteristics on the microstructure and properties of Al2O3–TiO2 plasma-sprayed coatings
Elsevier (2013-04)Atmospheric plasma spraying (APS) is an interesting technique to obtain nanostructured coatings due to its versatility, simplicity and relatively low cost. However, nanometric powders cannot be fed into the plume using ... -
Influence of the particle size on the microstructure and mechanical properties of grains containing mixtures of nanoparticles and microparticles: Levitator tests and pilot-scaled validation
Elsevier (2013)The spray drying process is used in many industrial applications. However, different grain properties can be desirable depending on the later use of the powders produced. In this work the influence of the particle size on ... -
Influence of the reactor configuration and the supporting electrolyte concentration on the electrochemical oxidation of Atenolol using BDD and SnO2 ceramic electrodes
Elsevier (2020)Electrochemical oxidation of β-blocker atenolol (ATL, 100 ppm) at different applied current densities (33, 50 and 83 mA·cm-2) using a reactor divided by an ion-exchange membrane and an undivided one was investigated. Two ... -
Influence of zinc molybdenum phosphate pigment on coatings performance studied by electrochemical methods
Elsevier (2016-08)The effect of the addition of the zinc molybdenum phosphate pigment, on the corrosion resistance properties of powder coating on steel, has been investigated by means of different electrochemical methods: electrochemical ... -
Influencia de los parámetros de proyección por plasma atmosférico en recubrimientos de YSZ obtenidos a partir de polvos micro y nanoestructurados
Elsevier (2014-07)En el presente trabajo se ha estudiado la influencia de cada uno de los parámetros de la proyección térmica por plasma atmosférico (atmospheric plasma spraying, APS) en la deposición de dos polvos comerciales de YSZ, uno ... -
Inkjet technology for ceramic products. Influence of some process variables on ink penetration
Wiley (2019-07-27)Inkjet technology has become very popular in recent years and is nowadays widely used for decorating ceramic products. This has led to in-depth study of the operating principles and process variables involved. These ... -
Inter-comparison of receptor models for PM source apportionment: Case study in an industrial area
Elsevier (2008)Receptor modelling techniques are used to identify and quantify the contributions from emission sources to the levels and major and trace components of ambient particulate matter (PM). A wide variety of receptor models ... -
Interaction of the chromium–iron black pigment with porcelanised stoneware
Elsevier (2013-09)A study has been undertaken on the interaction between the (Fe,Cr)2O3 black pigment and an industrial porcelanised stoneware composition at its firing temperature. The results indicate that the glassy phase that forms ... -
Introducing an ionic conductive matrix to the cold-sintered Li1.3Al0.3Ti1.7(PO4)3-based composite solid electrolyte to enhance the electrical properties
Elsevier (2023-08-09)In the present work, a Polymer-In-Ceramics (PIC) solid electrolyte based on Li1.3Al0.3Ti1.7(PO4)3 (LATP) and PEOn-LiTFSI (poly(ethylene oxide) - lithium bis(trifluoromethanesulfonyl)imide) is obtained via Cold Sintering ... -
Investigation of deformation behavior and fracture of ceramic coatings by the acoustic emission method
Springer Verlag (2017-03)The use of protective coatings on components of machines and mechanisms provides the greatest economic benefit at the lowest additional cost. Plasma spraying is one of the most productive, technologically advanced, and ... -
Iron zircon pigment synthesis: Proposal of a mixing index for the raw materials mixtures
Elsevier (2017)Iron zircon coral pigments are very interesting from an industrial point of view because of their high colouring power and their stability at high temperatures. However, the pigment's synthesis is particularly troublesome ... -
Kinetic model of the dissolution process of a zirconium white frit. Influence of the temperature
Elsevier (2015)The dissolution of a zirconium white frit has been studied in order to know the kinetics of the process. The concentrations of five cations (Ca, Mg, Zn, Si and B) have been determined by ICP-OES after carrying out the ... -
Kinetic study of calcite particle (powder) thermal decomposition: Part I
Elsevier (2008)In the first step of the firing cycle used to manufacture white-firing wall tile bodies, the calcium carbonate that is added, as a source of CaO, to the clay raw materials mixture used to form these bodies needs to decompose. ... -
Kinetic study of the thermal decomposition process of calcite particles in air and CO2 atmosphere
Elsevier (2013-05)The thermal decomposition process of calcite particles (0.45–3.60 mm average diameter), made up of porous agglomerates of very small CaCO3 microcrystals, was studied in the 975–1216 K temperature range. The experiments ... -
Kinetics of the transformations occurring during the firing process of an industrial spray-dried porcelain stoneware body
Elsevier (2022-03-08)Pressed compacts of an industrial spray-dried porcelain stoneware powder, consisting mainly of albite, quartz, kaolinite, and illite, were thermally treated at different temperatures and times. Fired test piece bulk density ... -
Large scale synthesis of nanostructured zirconia-based compounds from freeze-dried precursors
Elsevier (2013)Nanocrystalline zirconia powders have been obtained at the multigram scale by thermal decomposition of precursors resulting from the freeze-drying of aqueous acetic solutions. This technique has equally made possible to ... -
Lessons from the COVID-19 air pollution decrease in Spain: Now what?
(2021)We offer an overview of the COVID-19 -driven air quality changes across 11 metropolises in Spain with the focuson lessons learned on how continuing abating pollution. Trafficflow decreased by up to 80% during the lockdownand ... -
Lightweight Porcelain Stoneware by Engineered CeO2 Addition
Wiley (2010)The use of porcelain stoneware in innovative applications such as the covering of internal walls or the manufacturing of ventilated facades may be limited by its relatively high density. In this paper, we discuss the ...