Modeling microstructural damage of silicate-based ceramics and its influence on macroscopic fracture strength
Impacte
Scholar |
Altres documents de l'autoria: Gilabert Villegas, Francisco A.; Cantavella Soler, Vicente; Dal Bó, Marcelo; Sánchez-Vilches, Enrique
Metadades
Mostra el registre complet de l'elementcomunitat-uji-handle:10234/9
comunitat-uji-handle2:10234/7033
comunitat-uji-handle3:10234/8618
comunitat-uji-handle4:
INVESTIGACIONAquest recurs és restringit
http://dx.doi.org/10.1016/j.actamat.2014.01.026 |
Metadades
Títol
Modeling microstructural damage of silicate-based ceramics and its influence on macroscopic fracture strengthAutoria
Data de publicació
2014-05-15Editor
ElsevierCita bibliogràfica
GILABERT VILLEGAS, F. A.; CANTAVELLA SOLER, V.; DAL BÓ, M.; SÁNCHEZ VILLEGAS, E. J. Modeling microstructural damage of silicate-based ceramics and its influence on macroscopic fracture strength. Acta Materialia, Volume 70, (May 2014), pp. 30–44Tipus de document
info:eu-repo/semantics/articleVersió de l'editorial
http://www.sciencedirect.com/science/article/pii/S1359645414000354Paraules clau / Matèries
Resum
The aim of this work is to clarify the influence of quartz inclusions added to a vitreous matrix on the macroscopic fracture toughness (KICKIC). We use numerical simulations to model a silicate-based ceramic material ... [+]
The aim of this work is to clarify the influence of quartz inclusions added to a vitreous matrix on the macroscopic fracture toughness (KICKIC). We use numerical simulations to model a silicate-based ceramic material as a heterogeneous region composed of an isotropic brittle matrix and a distribution of embedded quartz inclusions. Using the material point method (MPM), we present a two-dimensional study, that albeit an approximation, sheds light on the role of the material composition in the fracture behavior observed in these ceramic materials. The value of KICKIC is calculated from the maximum strength obtained via computational analysis of a single-edge-notch tension specimen. The model test allows us to study in detail the effects occurring in a region close to the main notch. Additionally, to validate and understand our numerical findings, we fabricated and characterized experimentally a representative set of specimens with the same features as the numerical ones. We focus our attention on the effect of both the size and volume fraction of the dispersed phase, as well as the initial state of microcracking of the material and its influence on the macroscopic mechanical performance. The simulations have shown the decisive role played simultaneously by the volume fraction and typical size of the inclusions that are cracked during the cooling process. [-]
Publicat a
Acta Materialia, Volume 70, (May 2014)Drets d'accés
http://rightsstatements.org/vocab/CNE/1.0/
info:eu-repo/semantics/restrictedAccess
info:eu-repo/semantics/restrictedAccess
Apareix a les col.leccions
- QUI_Articles [299]