ListarQUI_Articles por tema "Mechanical properties"
Mostrando ítems 1-9 de 9
-
Caracterización mecánica y tribológica de recubrimientos diamond-like carbon aplicados por la técnica deposición química de vapor sobre baldosas cerámicas
Elsevier (2015)Modifying ceramic tile functionality in order to improve their performance is a continuous challenge for ceramic industry. One technique emerging as an alternative in the ceramic products is the use of advanced thin coatings ... -
Influence of composition on mechanical behaviour of porcelain tile. Part I: microstructural characterization and developed phases after firing
Elsevier (2010-03)The porcelain tile is a ceramic product with high technical and aesthetic performance, whose composition is formulated from a mixture of clay or kaolin, quartz and feldspar. This paper is the first part of a study focusing ... -
Influence of composition on mechanical behaviour of porcelain tile. Part II: mechanical properties and microscopic residual stress
Elsevier (2010-03)The influence of the starting composition on the mechanical properties of sintered porcelain tile was evaluated based on the linear elastic fracture mechanics. Tile compositions were prepared according to a simplex-centroid ... -
Influence of composition on mechanical behaviour of porcelain tile. Part III: Effect of the cooling rate of the firing cycle
Elsevier (2011)This paper is the third part of a study focusing on determining the influence of the porcelain tile composition on mechanical behaviour of sintered bodies. Tile compositions were prepared according to a simplex-centroid ... -
Influence of macroscopic residual stresses on the mechanical behavior and microstructure of porcelain tile
Elsevier (2008-09)The development of macroscopic residual stress, as in glass-tempering processes, was studied for porcelain tile. Mechanical strength was observed to increase less than might be theoretically expected, owing to deterioration ... -
Influence of the feedstock characteristics on the microstructure and properties of Al2O3–TiO2 plasma-sprayed coatings
Elsevier (2013-04)Atmospheric plasma spraying (APS) is an interesting technique to obtain nanostructured coatings due to its versatility, simplicity and relatively low cost. However, nanometric powders cannot be fed into the plume using ... -
Porous single-fired wall tile bodies: Influence of quartz particle size on tile properties
Elsevier (2010)This study examines the effect of quartz particle size in raw material composition customarily used for the manufacture of porous single-fired wall tile bodies on the characteristics of the green tiles and on the thermal ... -
Relationship between Young's modulus and temperature in porcelain tiles
Elsevier (2012)A focused research was conducted on samples prepared from an industrial porcelain tile composition containing quartz, used to produce ceramic floor tiles, with the aim of evaluating the variation of fired specimens’ Young's ... -
Synthesis and processing of nanocrystalline tungsten carbide: Towards cemented carbides with optimal mechanical properties
Elsevier (2011-01)Nanocrystalline tungsten carbide has been obtained by reduction/carburization at low temperature from precursors obtained by freeze-drying of aqueous solutions. Nanocrystalline WC powders with a adequate content of carbon ...