Effect of ceramic industrial particulate emission control on key components of ambient PM10
Impacto
Scholar |
Otros documentos de la autoría: Minguillón Bengochea, María Cruz; Monfort, Eliseo; Querol, Xavier; Alastuey, Andres; Celades López, Irina; Miró, José Vicente
Metadatos
Mostrar el registro completo del ítemcomunitat-uji-handle:10234/9
comunitat-uji-handle2:10234/7033
comunitat-uji-handle3:10234/8618
comunitat-uji-handle4:
INVESTIGACIONEste recurso está restringido
http://dx.doi.org/10.1016/j.jenvman.2009.01.016 |
Metadatos
Título
Effect of ceramic industrial particulate emission control on key components of ambient PM10Autoría
Fecha de publicación
2009Editor
ElsevierISSN
3014797Cita bibliográfica
Journal of Environmental Management, 90, 8, p. 2558-2567Tipo de documento
info:eu-repo/semantics/articlePalabras clave / Materias
Resumen
The relationship between specific particulate emission control and ambient levels of some PM10 components (Zn, As, Pb, Cs, Tl) was evaluated. To this end, the industrial area of Castellón (Eastern Spain) was selected, ... [+]
The relationship between specific particulate emission control and ambient levels of some PM10 components (Zn, As, Pb, Cs, Tl) was evaluated. To this end, the industrial area of Castellón (Eastern Spain) was selected, where around 40% of the EU glazed ceramic tiles and a high proportion of EU ceramic frits are produced. The PM10 emissions from the ceramic processes were calculated over the period 2000-2006, taking into account the degree of implementation of corrective measures throughout the study period. Abatement systems were implemented in the majority of the fusion kilns for frit manufacture in the area as a result of the application of the Directive 1996/61/EC, leading to a marked decrease in PM<sub>10</sub> emissions. By contrast, emissions from tile manufacture remained relatively constant because of the few changes in the implementation of corrective measures. On the other hand, ambient PM10 levels and composition measurements were carried out from 2002 to 2006. A high correlation between PM 10 emissions from frit manufacture and ambient levels of Zn, As, Pb and Cs (R2 from 0.61 to 0.98) was observed. On the basis of these results, the potential impact of the implementation of corrective measures to reduce emissions from tile manufacture was quantified, resulting in a possible decrease of 3-5 μg/m 3 and 2 μg/m3 in ambient mineral PM10 (on an annual basis) in urban and suburban areas, respectively. This relatively simple methodology allows us to estimate the direct effect of a reduction in primary particulate emissions on ambient levels of key particulate components, and to make a preliminary quantification of the possibilities of air quality improvement by means of further emission reduction. Therefore, it is a useful tool for developing future air quality plans in the study area and in other industrialised areas. © 2009 Elsevier Ltd. All rights reserved. [-]
Derechos de acceso
http://rightsstatements.org/vocab/InC/1.0/
info:eu-repo/semantics/restrictedAccess
info:eu-repo/semantics/restrictedAccess
Aparece en las colecciones
- QUI_Articles [296]