Alumina-zirconia coatings obtained by suspension plasma spraying from highly concentrated aqueous suspensions
Ver/ Abrir
Impacto
Scholar |
Otros documentos de la autoría: Carpio Cobo, Pablo; Salvador, M. D.; Borell, A.; Sánchez-Vilches, Enrique; Moreno, R.
Metadatos
Mostrar el registro completo del ítemcomunitat-uji-handle:10234/9
comunitat-uji-handle2:10234/7033
comunitat-uji-handle3:10234/8618
comunitat-uji-handle4:
INVESTIGACIONMetadatos
Título
Alumina-zirconia coatings obtained by suspension plasma spraying from highly concentrated aqueous suspensionsFecha de publicación
2016Editor
ElsevierISSN
0257-8972; 1879-3347Cita bibliográfica
CARPIO, P., et al. Alumina-zirconia coatings obtained by suspension plasma spraying from highly concentrated aqueous suspensions. Surface and Coatings Technology, 2016, vol. 307, p. 713-719Tipo de documento
info:eu-repo/semantics/articleVersión de la editorial
http://www.sciencedirect.com/science/article/pii/S0257897216309446Versión
info:eu-repo/semantics/submittedVersionPalabras clave / Materias
Resumen
Suspension plasma spraying (SPS) deposition represents an innovative technique to produce coatings that exhibit improved properties. However, the key to obtain coatings with superior functional properties relies on ... [+]
Suspension plasma spraying (SPS) deposition represents an innovative technique to produce coatings that exhibit improved properties. However, the key to obtain coatings with superior functional properties relies on the investigation of the suspensions as starting materials. For this reason, the present work deals with the suspension preparation for SPS process and its influence on the resulting coatings.
Laboratory-prepared 60/40 wt% alumina-zirconia suspensions were concentrated to avoid energy loss and were then successfully deposited by SPS technique. The liquid used was water instead of ethanol due to economical, environmental and safety reasons. The preparation of the suspension plays an important role in SPS process since stable and well-dispersed water suspensions are difficult to obtain. For this reason, colloidal behaviour characterisation of the starting particles as well as rheological optimisation of the feedstock suspensions were addressed in this research.
Suspensions with different solid loadings (up to 30 vol.% or 72 wt%) were deposited using several spraying distances. All coatings displayed a bimodal microstructure consisting in partially melted zones surrounded by a fully melted matrix. α-Al2O3 and t’-ZrO2 constituted the main crystalline phases, but differences in the microstructure and properties of the coatings were observed. From these results, some relations between starting suspension and spraying parameters with coating characteristics were found. Thus the optimal spraying distance becomes shorter when the suspension solid loading increases. [-]
Publicado en
Surface and Coatings Technology, 2016, vol. 307Derechos de acceso
© 2016 Elsevier B.V. All rights reserved.
http://rightsstatements.org/vocab/InC/1.0/
info:eu-repo/semantics/openAccess
http://rightsstatements.org/vocab/InC/1.0/
info:eu-repo/semantics/openAccess
Aparece en las colecciones
- QUI_Articles [300]