Buscar
Analysis of the development of microscopic residual stresses on quartz particles in porcelain tile
(Elsevier, 2008-10)
This paper examines the development of microscopic residual stresses on quartz particles in porcelain tile using the XRD technique. The study was conducted with a typical porcelain tile composition consisting of sodium ...
In-situ impedance spectrospocy to dentify mechanisms in cold sintering process of Li1,3Al0,3Ti1,7(PO4)3 (LATP) solid electrolyte
(Universitat Jaume I, 2023-09)
En 2021, sólo el 30 % de energía consumida mundialmente procedía de fuentes renovables. El
almacenamiento de energía permitiría compensar la intermitencia a la que está sujeta la generación de energía
limpia y, por tanto, ...
Preparación de electrolitos sólidos de X-BI203: (1-X)LI1.3AL0.3T1.7(PO4)3 por sinterización en frío
(Universitat Jaume I, 2023-09)
Actualmente el mundo afronta graves problemas energéticos derivados de la escasez de recursos así como del elevado impacto ambiental que presentan los combustibles fósiles. Como alternativa, el uso de energías renovables ...
Capas finas de ZrO2 para mejorar la resistencia quÌmica de vidriados mates de calcio
(Sociedad Española de Cerámica y Vidrio, 2012-05)
The chemical resistance of ceramic glazes susceptible to it, and more specifically the glazes formulated with a calcium matt
frit, is enhanced by depositing on the surface a thin layer of zirconium oxide. A stabilized ...
M.A.B. Revestimientos vítreos con propiedades bactericidas y fungicidas
(2013-04-11)
This report describes the mosaic M.A.B. (bactericide and fungicide) produced by Togama S.A. belonging to the group Fluidra
S.A., which has been awarded with the Silver Alfa Award by the Spanish Society of Ceramics and ...
Estudio y control automático de la operación de extrusión de baldosas cerámicas
(Sociedad Española de Cerámica y Vidrio, 2012-03)
The ever-larger tile sizes demanded by the market, the higher quality requirements, and the increasingly similar installation
to that of pressed products make it necessary to narrow the tolerance limits of final extruded ...
Low-cost ceramic membranes manufacture using INKJET technology for active layer deposition and validation on membrane bioreactors
(Elsevier, 2023-06-17)
The fabrication of eco-friendly ceramic membranes based on low-cost raw materials, using digital INKJET printing techniques for active layer deposition and its validation in a membrane bioreactor (MBR) has been studied. ...
Effect of kaolin addition on the sinter-crystallisation kinetics of compacts of a crystallising frit
(Elsevier, 2022-08-22)
Non-isothermal techniques were used to study the sintering and crystallisation kinetics of an anorthoclase- and diopside-devitrifying frit and mixtures of this frit with a commercial kaolin. Raising kaolin content was ...
Effect of exogenous treatments with encapsulated salicylic acid on Arabidopsis thaliana development
(Sociedad Española de Biología de Plantas, 2023-04-19)
Environmental stresses are the main consequences derived from climate change that affect crop
production and plants development. In response to these unfavorable conditions, plants undergo
changes at morphological, ...
Enhancing NiZn ferrite properties through microwave sintering: A comparative studyMejora de las propiedades de la ferrita de NiZn mediante sinterización por microondas: un estudio comparativo
(Elsevier, 2023-11-03)
The structural, microstructural, morphological, and electromagnetic properties of a micro- and nanostructured nickel–zinc ferrite ((Cu0.12Ni0.23Zn0.65)Fe2O4) were studied after sintering between 900 and 1100 °C. The ...