Design of multi-station manufacturing processes by integrating the stream-of-variation model and shop-floor data
Impacte
Scholar |
Altres documents de l'autoria: Abellán-Nebot, José V.; Liu, Jian; Romero Subirón, Fernando
Metadades
Mostra el registre complet de l'elementcomunitat-uji-handle:10234/9
comunitat-uji-handle2:10234/7034
comunitat-uji-handle3:10234/8619
comunitat-uji-handle4:
INVESTIGACIONAquest recurs és restringit
http://dx.doi.org/10.1016/j.jmsy.2011.04.001 |
Metadades
Títol
Design of multi-station manufacturing processes by integrating the stream-of-variation model and shop-floor dataData de publicació
2011-04Editor
ElsevierISSN
0278-6125Cita bibliogràfica
Journal of Manufacturing Systems Volume 30, Issue 2, April 2011Tipus de document
info:eu-repo/semantics/articleVersió de l'editorial
http://www.sciencedirect.com/science/article/pii/S0278612511000264Paraules clau / Matèries
Resum
Processdesign has been intensively studied to reduce dimensional variability of products produced in multi-stationmanufacturingprocesses (MMPs). Most of the existing studies focus on predicting variation propagation ... [+]
Processdesign has been intensively studied to reduce dimensional variability of products produced in multi-stationmanufacturingprocesses (MMPs). Most of the existing studies focus on predicting variation propagation and evaluating process robustness. However, these studies overlook the potential use of historical shop-floor quality data of existing MMPs in order to extract the actual manufacturing operation capabilities from each station, and then, to evaluate more accurately the expected dimensional variability of new candidate process plans. This paper proposes a methodology to improve process plan selection based on three components: (i) based on historical shopfloordata, an inference on the process capabilities of the stations in an existing MMP, which will be used to produce the new product; (ii) a sensitivity analysis of candidate process plans to identify critical fixtures and manufacturingstations/operations; and (iii) an optimal selection of candidate process plans. A case study is presented to demonstrate the effectiveness of the methodology. [-]
Drets d'accés
Copyright © 2011 The Society of Manufacturing Engineers. Published by Elsevier Ltd. All rights reserved.
http://rightsstatements.org/vocab/InC/1.0/
info:eu-repo/semantics/restrictedAccess
http://rightsstatements.org/vocab/InC/1.0/
info:eu-repo/semantics/restrictedAccess
Apareix a les col.leccions
- ESID_Articles [478]