Acoustic anomalous reflectors based on diffraction grating engineering
Visualitza/
Metadades
Mostra el registre complet de l'elementcomunitat-uji-handle:10234/9
comunitat-uji-handle2:10234/43662
comunitat-uji-handle3:10234/43643
comunitat-uji-handle4:
INVESTIGACIONMetadades
Títol
Acoustic anomalous reflectors based on diffraction grating engineeringAutoria
Data de publicació
2018Editor
American Physical SocietyISSN
2469-9969; 2469-9950Cita bibliogràfica
TORRENT, Daniel. Acoustic Anomalous Reflectors Based on Diffraction Grating Engineering. arXiv preprint arXiv:1804.08893, 2018.Tipus de document
info:eu-repo/semantics/articleVersió de l'editorial
https://journals.aps.org/prb/abstract/10.1103/PhysRevB.98.060101Versió
info:eu-repo/semantics/publishedVersionResum
We present an efficient method for the design of anomalous reflectors for acoustic waves. The approach is
based on the fact that the anomalous reflector is actually a diffraction grating in which the amplitude of all ... [+]
We present an efficient method for the design of anomalous reflectors for acoustic waves. The approach is
based on the fact that the anomalous reflector is actually a diffraction grating in which the amplitude of all the
modes is negligible except for the one traveling towards the desired direction. A supercell of drilled cavities in an
acoustically rigid surface is proposed as the basic unit cell, and analytical expressions for an inverse diffraction
problem are derived. It is found that the the number of cavities required for the realization of an anomalous
reflector is equal to the number of diffracted modes to cancel, and this number depends on the relationship
between the incident and reflected angles. Then, the “retroreflection” effect is obtained by just one cavity per unit
cell; also, with only two cavities it is possible to change the reflection angle of a normally incident wave, and
five cavities are enough to design a general retroreflector changing the incident and reflected angles at oblique
incidence. Finally, the concept of Snell’s law violation is extended not only to the incident and reflected angles,
but also to the plane in which it happens, and a device based on a single cavity in a square lattice is designed in
such a way that the reflection plane is rotated π/4 with respect to the plane of incidence. Numerical simulations
are performed to support the predictions of the analytical expressions, and an excellent agreement is found. [-]
Publicat a
PHYSICAL REVIEW B 98 (2018)Proyecto de investigación
ANR-10-LABX-42 ; ANR-10-IDEX-03-02 ; N00014-17-1-2445Drets d'accés
©2018 American Physical Society
http://rightsstatements.org/vocab/InC/1.0/
info:eu-repo/semantics/openAccess
http://rightsstatements.org/vocab/InC/1.0/
info:eu-repo/semantics/openAccess
Apareix a les col.leccions
- INIT_Articles [743]