Buscar
Adhesion assessment of bioactive coatings deposited by atmospheric plasma spraying
(Akadémiai Kiadó, 2017-07-09)
The aim of the present work is to prepare bioactive coatings by APS employing different spraying parameters and substrates in order to model the adhesion of the coatings and to determine the best parameters that allow to ...
Ecological low-cost ceramic membranes based on olive stones as pore former
(Universitat Politècnica de València. Research Institute for Industrial, Radiophysical and Environmental Safety (ISIRYM). Prometeo Research Group (Membrane Processes and Environmental Effluent Treatment), 2018-07-13)
They will address the obtained results so far regarding the manufacturing and validation of the REMEB ceramic membranes
Eco-friendly ceramic membranes for water reuse in a membrane bioreactor (MBR)
(Universitat Politècnica de València. Research Institute for Industrial, Radiophysical and Environmental Safety (ISIRYM). Prometeo Research Group (Membrane Processes and Environmental Effluent Treatment), 2018-07-10)
The main objective of this study is to develop and validate ceramic membranes at lower cost than the commercial ones, by including agricultural and industrial wastes in the composition, together with raw materials typically ...
Nanofriltration treatment for boron removal from ceramic industry wastewater
(Universitat Politècnica de València. Research Institute for Industrial, Radiophysical and Environmental Safety (ISIRYM). Prometeo Research Group (Membrane Processes and Environmental Effluent Treatment), 2018-07-11)
Water is a limited natural resource and in many regions of the planet, it is also scarce. Consequently, water management has become a very important issue in many traditional industrial sectors which are water consumers ...
Ink-jet technology applied to engineer low-cost ceramic membranes
(Universitat Politècnica de València. Research Institute for Industrial, Radiophysical and Environmental Safety (ISIRYM). Prometeo Research Group (Membrane Processes and Environmental Effluent Treatment), 2018-07-09)
This contribution analyses the suitability of the ceramic ink-jet technology to apply layers over a porous ceramic support, as the basis for a development of a standardized method to synthesize multilayer ceramic membranes.
Microstructure assessment of suspension plasma spraying coatings from multicomponent submicronic Y-TZP/Al2O3/SiC particles
(Elsevier, 2018-08-01)
In this research, Suspension Plasma Spraying (SPS) technique was used for the thermal deposition of a multicomponent mixture made up of an Y-TZP/Al2O3 matrix with SiC particles. Two suspensions of Y-TZP and Al2O3 with ...
Effect of fructose-containing feedstocks on the microstructure of multicomponent coatings deposited by suspension plasma spraying
(Elsevier, 2019-04)
This work addressed to investigate the use of fructose as an additive in the water-based suspension feedstock of a Y-TZP/Al2O3/SiC multicomponent coating manufactured by suspension plasma spraying. The effect of fructose ...
CuO improved (Sn,Sb)O2 ceramic anodes for electrochemical advanced oxidation processes
(American Ceramic Society, 2018-12)
Antimony‐doped tin oxide electrodes with CuO as sintering aid are presented as an economical alternative to metal‐based electrodes, intended for the electrooxidation process of emerging and recalcitrant organic contaminants ...
Microstructural and in vitro characterisation of 45S5 bioactive glass coatings deposited by Solution Precursor Plasma Spraying (SPPS)
(Elsevier, 2018-12-20)
The present work focused on the development of bioactive glass coatings employing Solution Precursor Plasma Spraying. Precursors of SiO2, CaO, Na2O and P2O5 were mixed in distilled water to prepare concentrated solutions ...
Influence of microstructure and magnetizing mechanisms on magnetic complex permeability (imaginary part) of a Cu-doped Ni-Zn polycrystalline ferrite
(Elsevier, 2021)
The complex permeability of the Cu-doped Ni–Zn polycrystalline ferrites is strongly dependent on microstructure, particularly on relative density (ϕ) and average grain size (G), as it has been shown in a previous ...