Developing CIGS solar cells on glass-ceramic substrates
Ver/ Abrir
Impacto
Scholar |
Otros documentos de la autoría: Fraga Chiva, Diego; BARRACHINA ALBERT, ESTER; Calvet Roures, Iván; Lyubenova, Teodora; Carda Castelló, Juan Bautista
Metadatos
Mostrar el registro completo del ítemcomunitat-uji-handle:10234/9
comunitat-uji-handle2:10234/7053
comunitat-uji-handle3:10234/8639
comunitat-uji-handle4:
INVESTIGACIONMetadatos
Título
Developing CIGS solar cells on glass-ceramic substratesAutoría
Fecha de publicación
2018Editor
ElsevierISSN
1873-4979; 0167-577XTipo de documento
info:eu-repo/semantics/articleVersión de la editorial
https://www.sciencedirect.com/science/article/pii/S0167577X18304750Versión
info:eu-repo/semantics/submittedVersionPalabras clave / Materias
Resumen
Cu(In,Ga)Se2 (CIGS) is a p-type semiconductor material and an attractive absorber for thin films solar cells due to its unique optical and electrical properties. The low cost of this technology is based on its appli ... [+]
Cu(In,Ga)Se2 (CIGS) is a p-type semiconductor material and an attractive absorber for thin films solar cells due to its unique optical and electrical properties. The low cost of this technology is based on its application on ecological substrates (glass, ceramic or glass-ceramic materials), effective uses of raw materials and lower thickness of the film (range from 1.5 to 3 µm). In this work, a new glass-ceramic substrate has been developed using industrial wastes materials (recycled glass, bottom ash and fly ash from a thermal power plant) used as support in thin film solar cell technology. The CIGS absorber has been synthesized by an easy and low-cost way of preparation using the co-precipitation method. The solar cell device has been completed and fully characterized. The obtained films were characterized by X-Ray diffraction (XRD), scanning electron microscope (SEM) and electrical characterization. The short circuit current (Jsc), open circuit voltage (Voc), fill factor (FF), and total area power conversion efficiency (η) of the device are 8,11 mA/cm2, 168,2 mV, 27,6% and 0,4% respectively. [-]
Publicado en
Materials Letters, Volume 221, 15 June 2018Proyecto de investigación
RTC-2014-2294-3Derechos de acceso
0167-577X/© 2018 Elsevier B.V. All rights reserved.
http://rightsstatements.org/vocab/InC/1.0/
info:eu-repo/semantics/openAccess
http://rightsstatements.org/vocab/InC/1.0/
info:eu-repo/semantics/openAccess
Aparece en las colecciones
- QUIO_Articles [702]