Sintering of raw glazes for floor and porcelain tiles: A non-isothermal kinetic model
Impacte
![Google Scholar](/xmlui/themes/Mirage2/images/uji/logo_google.png)
![Microsoft Academico](/xmlui/themes/Mirage2/images/uji/logo_microsoft.png)
Metadades
Mostra el registre complet de l'elementcomunitat-uji-handle:10234/9
comunitat-uji-handle2:10234/7033
comunitat-uji-handle3:10234/8618
comunitat-uji-handle4:
INVESTIGACIONAquest recurs és restringit
http://dx.doi.org/10.1016/j.ceramint.2016.07.136 |
Metadades
Títol
Sintering of raw glazes for floor and porcelain tiles: A non-isothermal kinetic modelAutoria
Data de publicació
2016-11Editor
ElsevierCita bibliogràfica
AMORÓS, J. L., et al. Sintering of raw glazes for floor and porcelain tiles: A non-isothermal kinetic model. Ceramics International, 2016, vol. 42, no 14, p. 16169-16179.Tipus de document
info:eu-repo/semantics/articleVersió de l'editorial
http://www.sciencedirect.com/science/article/pii/S0272884216312019Paraules clau / Matèries
Resum
New fritless glaze compositions have been developed for floor and porcelain tiles from a new boron raw material obtained by calcination. The complexity of this type of composition also translates into complex behaviour ... [+]
New fritless glaze compositions have been developed for floor and porcelain tiles from a new boron raw material obtained by calcination. The complexity of this type of composition also translates into complex behaviour during firing in which, concurrently or in partially overlapping form, very different processes take place, such as crystalline phase dissolution, the crystallisation of new phases, and sintering phenomena. This paper analyses the physico-chemical transformations that develop during the firing of these new glaze compositions, focusing in particular on the sintering process and sintering kinetics. A multi-step kinetic model was developed in this study to encompass complex glaze compositions (containing up to nine components). The model appropriately describes the sintering degree of progress of five materials (a boron raw material and four glazes) with temperature, in constant-rate heating experiments, determined using hot stage microscopy (HSM). For the three glazes with the lowest starting amorphous phase content, sintering was assumed to take place in three individual, parallel and partially overlapping, steps. Sintering of the boron raw material was described by a single step, whereas for the fourth glaze, with a starting amorphous phase content intermediate between that of the raw material and the other glazes, two steps were needed. The evolution of crystalline phase content with temperature was used to identify the sintering mechanisms in each step. For each step, the kinetic model, pre-exponential factor, and activation energy were determined and related to the composition of the materials. As a novelty, the Avrami–Erofeev model, which is usually applied in describing the kinetics of chemical reactions and phase transitions, was used to describe each individual step. [-]
Publicat a
Ceramics International Volume 42, Issue 14, November 2016Drets d'accés
© 2016 Elsevier Ltd and Techna Group S.r.l. All rights reserved.
http://rightsstatements.org/vocab/InC/1.0/
info:eu-repo/semantics/restrictedAccess
http://rightsstatements.org/vocab/InC/1.0/
info:eu-repo/semantics/restrictedAccess
Apareix a les col.leccions
- QUI_Articles [298]