Recombination reduction on lead halide perovskite solar cells based on low temperature synthesized hierarchical TiO2 nanorods
Visualitza/
Impacte
Scholar |
Altres documents de l'autoria: Jaramillo Quintero, Óscar A.; Solís de la Fuente, Mauricio; S. Sánchez, Rafael; Recalde, Ileana B.; Juarez-Perez, Emilio J.; Rincón, Marina; Mora-Sero, Ivan
Metadades
Mostra el registre complet de l'elementcomunitat-uji-handle:10234/9
comunitat-uji-handle2:10234/2507
comunitat-uji-handle3:10234/6973
comunitat-uji-handle4:
INVESTIGACIONMetadades
Títol
Recombination reduction on lead halide perovskite solar cells based on low temperature synthesized hierarchical TiO2 nanorodsAutoria
Data de publicació
2016Editor
Royal Society of ChemistryISSN
2040-3364; 2040-3372Tipus de document
info:eu-repo/semantics/articleVersió de l'editorial
http://pubs.rsc.org/en/content/articlelanding/2016/nr/c5nr06692a#!divAbstractVersió
info:eu-repo/semantics/publishedVersionParaules clau / Matèries
Resum
Intensive research on the electron transport material (ETM) has been pursued to improve the efficiency of perovskite solar cells (PSCs) and decrease their cost. More importantly, the role of the ETM layer is not yet ... [+]
Intensive research on the electron transport material (ETM) has been pursued to improve the efficiency of perovskite solar cells (PSCs) and decrease their cost. More importantly, the role of the ETM layer is not yet fully understood, and research on new device architectures is still needed. Here, we report the use of three-dimensional (3D) TiO2 with a hierarchical architecture based on rutile nanorods (NR) as photoanode material for PSCs. The proposed hierarchical nanorod (HNR) films were synthesized by a two-step low temperature (180 °C) hydrothermal method, and consist of TiO2 nanorod trunks with optimal lengths of 540 nm and TiO2 nanobranches with lengths of 45 nm. Different device configurations were fabricated with TiO2 structures (compact layer, NR and HNR) and CH3NH3PbI3, using different synthetic routes, as the active material. PSCs based on HNR-CH3NH3PbI3 achieved the highest power conversion efficiency compared to PSCs with other TiO2 structures. This result can be ascribed mainly to lower charge recombination as determined by impedance spectroscopy. Furthermore, we have observed that the CH3NH3PbI3 perovskite deposited by the two-step route shows higher efficiency, surface coverage and infiltration within the structure of 3D HNR than the one-step CH3NH3PbI3−xClx perovskite. [-]
Publicat a
Nanoscale, 2016, vol. 8, núm. 12Drets d'accés
This journal is © The Royal Society of Chemistry 2016. Jaramillo-Quintero, O. A., de la Fuente, M. S., Sanchez, R. S., Recalde, I. B., Juarez-Perez, E. J., Rincón, M. E., & Mora-Seró, I. (2016). Recombination reduction on lead halide perovskite solar cells based on low temperature synthesized hierarchical TiO 2 nanorods. Nanoscale, 2016, vol. 8, núm. 12 <http://dx.doi.org/10.1039/C5NR06692A> -- Reproduced by permission of The Royal Society of Chemistry
http://rightsstatements.org/vocab/InC/1.0/
info:eu-repo/semantics/openAccess
http://rightsstatements.org/vocab/InC/1.0/
info:eu-repo/semantics/openAccess
Apareix a les col.leccions
- INAM_Articles [506]
- FCA_Articles [501]