Manufacturing variation models in multi-station machining systems
Ver/ Abrir
Impacto
Scholar |
Otros documentos de la autoría: Abellán-Nebot, José V.; Romero Subirón, Fernando; Serrano Mira, Julio
Metadatos
Mostrar el registro completo del ítemcomunitat-uji-handle:10234/9
comunitat-uji-handle2:10234/7034
comunitat-uji-handle3:10234/8619
comunitat-uji-handle4:
INVESTIGACIONMetadatos
Título
Manufacturing variation models in multi-station machining systemsFecha de publicación
2013Editor
Springer VerlagISSN
0268-3768; 1433-3015Cita bibliográfica
The International Journal of Advanced Manufacturing Technology January 2013, Volume 64, Issue 1-4, pp 63-83Tipo de documento
info:eu-repo/semantics/articleVersión de la editorial
http://link.springer.com/article/10.1007%2Fs00170-012-4016-4Palabras clave / Materias
Resumen
In product design and quality improvement fields, the development of reliable 3D machining variation models for multi-station machining processes is a key issue to estimate the resulting geometrical and dimensional ... [+]
In product design and quality improvement fields, the development of reliable 3D machining variation models for multi-station machining processes is a key issue to estimate the resulting geometrical and dimensional quality of manufactured parts, generate robust process plans, eliminate downstream manufacturing problems, and reduce ramp-up times. In the literature, two main 3D machining variation models have been studied: the stream of variation model, oriented to product quality improvement (fault diagnosis, process planning evaluation and selection, etc.), and the model of the manufactured part, oriented to product and manufacturing design activities (manufacturing and product tolerance analysis and synthesis). This paper reviews the fundamentals of each model and describes step by step how to derive them using a simple case study. The paper analyzes both models and compares their main characteristics and applications. A discussion about the drawbacks and limitations of each model and some potential research lines in this field are also presented. [-]
Publicado en
The International Journal of Advanced Manufacturing Technology, 2013, vol. 64, no 1-4Derechos de acceso
© Springer. The final publication is available at Springer via http://dx.doi.org/10.1007/s00170-012-4016-4
http://rightsstatements.org/vocab/InC/1.0/
info:eu-repo/semantics/openAccess
http://rightsstatements.org/vocab/InC/1.0/
info:eu-repo/semantics/openAccess
Aparece en las colecciones
- ESID_Articles [478]