An experimental study of process variables in turning operations of Ti–6Al–4V and Cr–Co spherical prostheses
Impacte
![Google Scholar](/xmlui/themes/Mirage2/images/uji/logo_google.png)
![Microsoft Academico](/xmlui/themes/Mirage2/images/uji/logo_microsoft.png)
Metadades
Mostra el registre complet de l'elementcomunitat-uji-handle:10234/9
comunitat-uji-handle2:10234/7034
comunitat-uji-handle3:10234/8619
comunitat-uji-handle4:
INVESTIGACIONAquest recurs és restringit
http://dx.doi.org/10.1007/s00170-012-3955-0 |
Metadades
Títol
An experimental study of process variables in turning operations of Ti–6Al–4V and Cr–Co spherical prosthesesData de publicació
2012Editor
Springer VerlagISSN
0268-3768; 1433-3015Cita bibliogràfica
The International Journal of Advanced Manufacturing Technology December 2012, Volume 63, Issue 9-12, pp 887-902Tipus de document
info:eu-repo/semantics/articleVersió de l'editorial
http://link.springer.com/article/10.1007%2Fs00170-012-3955-0Paraules clau / Matèries
Resum
Ti–6Al–4V and Cr–Co alloys are extensively used in manufacturing prostheses due to their biocompatibility, high strength-to-weight ratio and high resistance to corrosion and wear. However, machining operations involving ... [+]
Ti–6Al–4V and Cr–Co alloys are extensively used in manufacturing prostheses due to their biocompatibility, high strength-to-weight ratio and high resistance to corrosion and wear. However, machining operations involving Ti–6Al–4V and Cr–Co alloys face a series of difficulties related to their low machinability which complicate the process of controlling the quality levels required in these parts. The main objective of this paper is to study the influence of cutting parameters, machine tool control accuracy and metrology procedures on surface roughness parameters and form errors in contouring operations of Ti–6Al–4V and Cr–Co workpieces. The machining performance of the two biocompatible materials is compared, focusing the study on part quality at low feed per revolution and the stochastic nature of plastic deformations at this regime. The results showed a better surface roughness control for Ti–6Al–4V, whereas for Cr–Co alloys, the performance presents high variability. In the case of form errors (sphericity), contouring errors and metrology procedures are important factors to be considered for quality assurance. In addition, the study analyses the correlation of the machining performance with different sensor signals acquired from a low cost non-intrusive multi-sensor, showing a high correlation of signals from acoustic emission sensors and accelerometers in the machining of spherical features on Ti–6Al–4V parts. The findings of this research work can be taken into account when designing prostheses components and planning their manufacturing processes. [-]
Publicat a
The International Journal of Advanced Manufacturing Technology December (2012), vol. 63, num. 9-12Drets d'accés
© Springer, Part of Springer Science+Business Media
http://rightsstatements.org/vocab/InC/1.0/
info:eu-repo/semantics/restrictedAccess
http://rightsstatements.org/vocab/InC/1.0/
info:eu-repo/semantics/restrictedAccess
Apareix a les col.leccions
- ESID_Articles [477]