Computerized Generation and Finite Element Stress Analysis of Endodontic Rotary File
![Thumbnail](/xmlui/bitstream/handle/10234/193249/75406.pdf.jpg?sequence=5&isAllowed=y)
Visualitza/
Impacte
![Google Scholar](/xmlui/themes/Mirage2/images/uji/logo_google.png)
![Microsoft Academico](/xmlui/themes/Mirage2/images/uji/logo_microsoft.png)
Metadades
Mostra el registre complet de l'elementcomunitat-uji-handle:10234/9
comunitat-uji-handle2:10234/7035
comunitat-uji-handle3:10234/8617
comunitat-uji-handle4:
INVESTIGACIONMetadades
Títol
Computerized Generation and Finite Element Stress Analysis of Endodontic Rotary FileAutoria
Data de publicació
2021-05-02Editor
Computerized Generation and Finite Element Stress Analysis of Endodontic Rotary FileISSN
2076-3417Cita bibliogràfica
Roda-Casanova, V.; Zubizarreta-Macho, Á.; Sanchez-Marin, F.; Alonso Ezpeleta, Ó.; Albaladejo Martínez, A.; Galparsoro Catalán, A. Computerized Generation and Finite Element Stress Analysis of Endodontic Rotary Files. Appl. Sci. 2021, 11, 4329. https://doi.org/10.3390/app11104329Tipus de document
info:eu-repo/semantics/articleVersió de l'editorial
https://www.mdpi.com/2076-3417/11/10/4329/htmVersió
info:eu-repo/semantics/publishedVersionParaules clau / Matèries
Resum
Introduction: The finite element method has been extensively used to analyze the mechanical behavior of endodontic rotary files under bending and torsional conditions. This methodology requires elevated computer-aided ... [+]
Introduction: The finite element method has been extensively used to analyze the mechanical behavior of endodontic rotary files under bending and torsional conditions. This methodology requires elevated computer-aided design skills to reproduce the geometry of the endodontic file, and also mathematical knowledge to perform the finite element analysis. In this study, an automated procedure is proposed for the computerized generation and finite element analysis of endodontic rotary files under bending and torsional conditions. Methods: An endodontic rotary file with a 25mm total length, 0.25mm at the tip, 1.20mm at 16mm from the tip, 2mm pitch and squared cross section was generated using the proposed procedure and submitted for analysis under bending and torsional conditions by clamping the last 3mm of the endodontic rotary file and applying a transverse load of 0.1N and a torsional moment of 0.3N⋅cm. Results: The results of the finite element analyses showed a maximum von Mises stress of 398MPa resulting from the bending analysis and a maximum von Mises stress of 843MPa resulting from the torsional analysis, both of which are next to the encastre point. Conclusions: The automated procedure allows an accurate description of the geometry of the endodontic file to be obtained based on its design parameters as well as a finite element model of the endodontic file from the previously generated geometry. [-]
Publicat a
Applied Sciences, 2021, vol. 11, no 10Drets d'accés
info:eu-repo/semantics/openAccess
Apareix a les col.leccions
- EMC_Articles [822]
Els següents fitxers sobre la llicència estan associats a aquest element: