Effect of debris size on the tribological performance of thermally sprayed coatings
![Thumbnail](/xmlui/bitstream/handle/10234/187371/67950.pdf.jpg?sequence=4&isAllowed=y)
Visualitza/
Impacte
![Google Scholar](/xmlui/themes/Mirage2/images/uji/logo_google.png)
![Microsoft Academico](/xmlui/themes/Mirage2/images/uji/logo_microsoft.png)
Metadades
Mostra el registre complet de l'elementcomunitat-uji-handle:10234/9
comunitat-uji-handle2:10234/7034
comunitat-uji-handle3:10234/8619
comunitat-uji-handle4:
INVESTIGACIONMetadades
Títol
Effect of debris size on the tribological performance of thermally sprayed coatingsData de publicació
2020Editor
ElsevierISSN
0301-679X; 1879-2464Cita bibliogràfica
HABIB, K. A., et al. Effect of debris size on the tribological performance of thermally sprayed coatings. Tribology International, 2020, vol. 143, p. 106025Tipus de document
info:eu-repo/semantics/articleVersió de l'editorial
https://www.sciencedirect.com/science/article/pii/S0301679X19305420Versió
info:eu-repo/semantics/submittedVersionParaules clau / Matèries
Resum
This research aims to assess the effect of the debris particle size on the tribological performance
and lubrication regime parameters of a Ni-based alloy coating. This is a key industrial problem,
and its resolution ... [+]
This research aims to assess the effect of the debris particle size on the tribological performance
and lubrication regime parameters of a Ni-based alloy coating. This is a key industrial problem,
and its resolution can contribute to better machine endurance and proper maintenance.
The debris particles are simulated by hard Al2O3 particles of size ranging from nanometers to 45
μm and dispersed in an oil lubricant. The coating studied is NiCrBSi deposited by flame spraying
technique followed by the Surface Flame Melting (SFM) process. The counterpart disk sample
was fabricated from quenched and tempered F-5220 steel (in line with A681(O1) ASTM). This
pair was tested under linear sliding contact.
Our results show that the addition of alumina particles contributes to a significant increase in
wear, particularly for the largest particles (micrometric size). In the case of micrometric particles,
it is possible to observe the formation of higher surface roughness, numerous microgrooves, and
plastic flow of NiCrBSi coating perpendicular to the sliding direction, resulting in higher loss of
volume.
It was found that the actual surface roughness (obtained as a function of the debris particle size)
allows better identification and prediction of the lubrication regime for wear processes instead of
the traditional approach that uses the initial surface roughness as a parameter. [-]
Publicat a
Tribology International, 2020, vol. 143, p. 106025Drets d'accés
http://rightsstatements.org/vocab/CNE/1.0/
info:eu-repo/semantics/openAccess
info:eu-repo/semantics/openAccess
Apareix a les col.leccions
- ESID_Articles [477]