Buscar
Testing the performance of one and two box models as tools for risk assessment of particle exposure during packing of inorganic fertilizer
(Elsevier, 2019)
Modelling of particle exposure is a useful tool for preliminary exposure assessment in
workplaces. However, actual exposure measurements are needed to assess models
reliability. Worker exposure was monitored during packing ...
Microstructural and in vitro characterisation of 45S5 bioactive glass coatings deposited by Solution Precursor Plasma Spraying (SPPS)
(Elsevier, 2018-12-20)
The present work focused on the development of bioactive glass coatings employing Solution Precursor Plasma Spraying. Precursors of SiO2, CaO, Na2O and P2O5 were mixed in distilled water to prepare concentrated solutions ...
Non-isothermal sintering of powdered vitrified composites. A kinetic model
(Elsevier, 2019)
This report sets out the results obtained on studying the sintering process of glass–zircon composites,
analysing the microstructural changes that developed on modifying zircon content. The sintering of composites with ...
Beyond the energy balance: Exergy analysis of an industrial roller kiln firing porcelain tiles
(Elsevier, 2019-03)
The ceramic tile manufacturing process consumes large amounts of energy, mainly in the firing stage. Firing usually takes place in natural gas-fuelled continuous roller kilns, the most widely used tile firing facilities ...
Low-cost ceramic membranes: A research opportunity for industrial application
(Elsevier, 2019-03)
Obtaining low-cost ceramic membranes has attracted great interest in the scientific community in last years, as it allows to preserve the advantages of ceramic materials while significantly reduce their manufacturing costs. ...
Residual stresses in porcelain tiles. Measurement and process variables assessment
(Elsevier, 2019-04-22)
This research addresses the residual stresses phenomenon taking place during the manufacture of porcelain tiles. Residual stresses were quantified by the strain relaxation slotting method. The method is based on the fact ...
Grain coarsening during liquid phase sintering of zircon-glass composites
(Elsevier, 2023-08-09)
This study examined zircon grain growth during isothermal sintering of a zircon-glass composite with a zircon volume fraction of 0.525 zircon volume/solids volume, at a temperature of 1200 degrees C, with different residence ...
Modelización de la sorción en baldosas Cerámicas reguladoras de la humedad ambiental
(Universitat Jaume I, 2023-09-13)
El desarrollo de viviendas confortables con menor consumo energético implica un aumento del aislamiento
térmico y una reducción en la ventilación de los espacios interiores, lo que puede dar lugar a ambientes con
condiciones ...
Novel Sb-doped SnO2 ceramic anode coated with a photoactive BiPO4 layer for the photoelectrochemical degradation of an emerging pollutant
(Elsevier, 2023-06-08)
In the present work, a study about the electrochemical and photoelectrochemical degradation of an emerging pollutant using an Sb-doped SnO2 anode coated with a photocatalytic layer of BiPO4 has been performed. The ...
Introducing an ionic conductive matrix to the cold-sintered Li1.3Al0.3Ti1.7(PO4)3-based composite solid electrolyte to enhance the electrical properties
(Elsevier, 2023-08-09)
In the present work, a Polymer-In-Ceramics (PIC) solid electrolyte based on Li1.3Al0.3Ti1.7(PO4)3 (LATP) and PEOn-LiTFSI (poly(ethylene oxide) - lithium bis(trifluoromethanesulfonyl)imide) is obtained via Cold Sintering ...