Theoretical evaluation of different high-temperature heat pump configurations for low-grade waste heat recovery
Ver/ Abrir
Impacto
Scholar |
Otros documentos de la autoría: Mateu-Royo, Carlos; Navarro-Esbrí, Joaquín; Mota-Babiloni, Adrián; Amat-Albuixech, Marta; Moles, Fran
Metadatos
Mostrar el registro completo del ítemcomunitat-uji-handle:10234/9
comunitat-uji-handle2:10234/7035
comunitat-uji-handle3:10234/8617
comunitat-uji-handle4:
INVESTIGACIONMetadatos
Título
Theoretical evaluation of different high-temperature heat pump configurations for low-grade waste heat recoveryAutoría
Fecha de publicación
2018-06Editor
ElsevierCita bibliográfica
Carlos Mateu-Royo , Joaquín Navarro-Esbrí , Adrian Mota-Babiloni , Marta Amat-Albuixech , Francisco Moles , Theoretical evaluation of different high-temperature heat « pump configurations for low-grade waste heat recovery, International Journal of Refrigeration (2018), doi: 10.1016/j.ijrefrig.2018.04.017Tipo de documento
info:eu-repo/semantics/articleVersión de la editorial
https://www.sciencedirect.com/science/article/pii/S0140700718301233#ack0001Versión
info:eu-repo/semantics/acceptedVersionPalabras clave / Materias
Resumen
The introduction of high-temperature heat pumps for waste heat recovery with low GWP refrigerants can reduce the greenhouse gas emissions in the industrial sector. This article evaluates the energy performance and the ... [+]
The introduction of high-temperature heat pumps for waste heat recovery with low GWP refrigerants can reduce the greenhouse gas emissions in the industrial sector. This article evaluates the energy performance and the volumetric heating capacity of five vapour compression system configurations using n-Pentane, Butane, HCFO-1233zd(E) and HFO-1336mzz(Z) as HFC-245fa low GWP alternative fluids for heating production at temperatures of 110, 130 and 150°C and different temperature lifts. The selected architectures and the equations are presented, and the most appropriate method to calculate the intermediate pressure is selected. The results of the simulation show that single-stage cycle with an internal heat exchanger (IHX) becomes the most efficient configuration at lower temperature lifts whereas two-stage cycle with IHX at higher lifts. While n-Pentane provides the highest energy performance values, Butane (only up to 130°C) and HCFO-1233zd(E) highlight in the heating volumetric capacities. HFO-1336mzz(Z) provides intermediate values in both parameters. Consequently, the working fluid selection is highly dependent on the specifications and the energetic and installation costs. [-]
Proyecto de investigación
Spanish Government (ENE2015-70610-R and RTC-2015-4193-3) ; Universitat Jaume I (grant POSDOC/2016/23 and P1-1B2015-38)Derechos de acceso
© 2018 Elsevier Ltd and IIR. All rights reserved.
info:eu-repo/semantics/openAccess
info:eu-repo/semantics/openAccess
Aparece en las colecciones
- EMC_Articles [803]